- 最后登录
- 2018-6-29
- 在线时间
- 2171 小时
- 威望
- 1286
- 金币
- 1286
- 注册时间
- 2016-5-10
- 阅读权限
- 120
- 主题
- 772
- 精华
- 0
- 积分
- 3434
- 帖子
- 772
该用户从未签到
|
20th century European-style device is imported from Europe and 80 outdoor box Transformer substation Cable to connect the concept of a reference towards the?cable distribution boxes?inside the field, the American device sucked from the United States introduction of the age of 90 seat-mounted box Transformer substation The concept of reference into the cable plug for the cable distribution box. 1 European components and devices of various points of American European and American devices have no clearly defined boundaries, our understanding with the sector are also inconsistent.
They’re slightly different overall performance and cost, uncover out the difference among the function of the selection is fairly important. 1.1 devices with diverse insulation American conductor devices available surrounded by three layers of rubber, one of the most inner semi-conductor shielding layer, middle layer-based insulation layers,Cheap Jerseys, the outermost permanent ground for the semi-conductor shielding layer, to ensure that shielded the cost fairly high. European-style two-story device appearance of bread wrapped in rubber, not the most external stratum. 1.2 branch circuit to connect the idea of distinct European device serial branch mode, about numerous silicone rubber insulated T-type device from the direction with the short arm of one particular by a single, connected in series to form the main loop, every single T piece from the long arm from the branch leads to. This method has some weak points in series branch: If a branch road from the T piece fails, then the series components must remain removed, the removal of defective parts to re-group T-series can continue following the run ended when troubleshooting, component also must attempt once again and re-splitting, much more difficulty; over the very first series with the main circuit, affecting the reliability of electrical conductivity and decrease dynamic stability; when bigger series with elements,Cheap NFL Jerseys co, the axis is difficult to help keep a straight line, major to some of the bonding interface deviate from the normal position, the interface of dielectric strength and capability will minimize water seepage.
The American branch of device was utilized in parallel mode, just to get over the series branch from the faults. Parallel branch is within the distribution boxes of the box walls fixed a (three-phase) is called the parent row in the insulation board devices, which play the function of convergence bus. Mother board features a number of row Electric Outside the cone on the parallel connection seat, no matter inlet and outlet, branch lines as well as other cables all connected towards the bus bar plate. Busbar internal conductor is silver plate welding, conductive trustworthy, but larger difference among three-phase, phase jumper cable to some extent more challenging, and also the three-phase bus bar plate lined up the length from the box size will grow to be larger. 1.three using the surface from the cone taper distinct European tie by German standards DIN47636 taper style,Cheap NFL Jerseys Wholesale, the water seepage American device performance is slightly better than the European-style device. four European and American devices device principle of distinction Domestic production patch devices, some factories will likely be in Europe, the United states of america along with the two kind of structures, mixed, a lot more hard to distinguish. The following 3 fundamental ideas will help us determine: A) the device from the patch branch structure,Cheap NFL Jerseys 2016. This article from FiberStore |
|
浙公网安备 33010602000859号
QQ空间
腾讯微博
腾讯朋友
收藏